
Pressure independent control valves
Product types shown: 2

AFQMP 2
AFQMP 2 is a self-acting flow controller with integrated control valve and with pressure actuator with adjustable spring, developed for the use in district heating / cooling systems. The controller prevents flow to exceed set max flow. Pressure actuator with adjustable spring enables adjustment of differential pressure over the control cone from 0.1 to 1 bar. Increased flows can be provided. In a combination with electrical actuators AMV(E) and ECL electronic controllers the flow and temperature can be controlled to achieve highest energy savings.
AFQMP 2 has a control valve with adjustable flow limiter, connection neck for electrical actuator and a pressure actuator with one control diaphrag.
Controllers are used together with Danfoss electrical actuators:
- AFQMP 2 PN 16/25/40 DN 65-250
- AMV(E) 655 without spring return function and with manual operation;
- AMV(E) 658 SD 2) spring return function and manual operation;
- AMV(E) 659 SD 1) spring return function;
- AMV(E) 55
- AFQMP 2 PN 16/25/40 DN 65-125
- AMV(E) 56
1) DIN approved (according to EN 14597)
2) not DIN approved
Together with Danfoss intelligent electrical actuator AMEi 6 intelligent optimization functions are available:
∙ iSET-intelligent substation efficiency optimization
∙ iNET-intelligent pump optimization
Intelligent electrical actuator AMEi 6 iSET
AMEi 6 iSET actuator for intelligent optimization of the District Heating/Cooling substation operation. Automatic adjustment of Δp setting on AFP 2, AFPB 2, AFPQ 2 and AFQMP 2 controllers, used in DHC systems.
Solution for dynamic DH systems with wide span of min - max flow (Domestic Hot Water service) and for systems with improperly sized control equipment (oversized control valves, wrong valve selection/characteristic, poor control ratio...).
Auto stabilization function monitors control signal and stabilizes oscillations at the partial/ low load operating conditions, by adjustment of the Δp over the motorized control valve (MCV).
Constant-real time MCV operation improvement led to more stable control without oscillations and flow delivered up to the real needs (overflow prevention).
This results in stable temperature conditions on the secondary side, improvement of ΔT on the primary side and longer lifetime of installed equipment.